Here's how it works
For an approx. 4 cm wide Bracelet stretch 28 warp threads onto the bead weaving frame. Cut off a Perlon thread as long as possible and knot it on the left outer edge of the warp threads. If the thread should run out on Weaving , knot it on the right outer warp thread and start with a new Perlon thread, which is knotted on the left warp thread.
Next, measure the circumference of the wrist with a tape measure and make a corresponding mark on the warp threads. Now thread 29 rocailles for each row according to the pattern and press them up under the warp threads with the index finger of the left hand so that the rocailles are between the warp threads
Then thread from the right side with the bead-raising needle over the warp threads through the beads. In this way weave the entire Bracelet according to the pattern. When the mark is reached, knot the weaving thread on the right outer edge of the warp threads.
Remove the finished Bracelet from Weaving frame On one side of the bracelet, divide the warp threads into two halves, making a knot in each half. Then knot both halves with a double knot, including a lobster clasp. Now shorten the remaining warp threads up to the knot. On the other side of the bracelet knot all warp threads together, then cut off 1 cm before the knot
Finally fasten a connecting cap with a strip at the end of the warp threads.
