First prepare the metal frames for the later procedure. To do this, cut adhesive tape into thin strips and stick them under the edges of the metal sockets as a base. Again, it is best to place the sockets on a silicone mat. Thanks to the adhesive tape, the resin cannot run out at the bottom.
Mix the resin according to the instructions. It is best to blow dry the resin a little with the embossing dryer while it is still in the container so that any bubbles that form are reduced. Then pour the resin into the metal frames up to the top. Now blow dry the resin lightly with the embossing dryer. This will again reduce bubbles and give you a smoother surface.
Decorate your jewellery as desired with glitter, colour and flowers. The glitter is sprinkled on the wet resin, the colour is mixed into the resin with a skewer (looks similar to marbled) and the flowers can be easily arranged on the resin. For complete colouring from the resin, it is mixed in separate containers and then placed in the metal frame.
After a drying time of approx. 24 hours, remove the tape and if necessary sand the edges clean with a polishing attachment e.g. Proxxon or very fine sandpaper. If the reverse side should be milky matt, you can mix resin and apply it to the reverse side with a brush and let it dry again for 24 hours. You can also brush the surface again with clear resin.
Finally, mount the pendants on the chains.
